A Camshaft Profile Actuator A Control Circuit/Open Bank 2

Where it lives

For P001D, the actuator sits on the circuit this code reports. The description of P001D puts it on bank 2.

Check these first

• An open in the bank 2 actuator A control wire
• A failed bank 2 camshaft profile actuator A solenoid
• Corroded pins at the bank 2 actuator connector
• Low oil pressure at the bank 2 phaser
• A failed ECM driver for the bank 2 actuator A

What to do next

1. Inspect the bank 2 actuator A connector and harness for an open
2. Measure the bank 2 actuator A solenoid resistance
3. Check oil pressure and condition at the bank 2 phaser
4. Verify control voltage at the actuator with the key on
5. Replace the bank 2 actuator A if the circuit tests good but the fault stays
6. Clear the code and retest

Look up another code