OBD A Camshaft Position Control Performance Bank 2
What it means
P25E2 stands for A Camshaft Position Control Performance Bank 2. P25E2 is a P code, so the fault sits in the engine, transmission and emissions systems. For P25E2, the second digit places it in speed and idle control. For P25E2, work through the cause list below, cheapest checks first.
What to check first
For P25E2, check the bank 2 reading against the other bank before buying parts, since if only one side is out of range that side is the fault.
Check these first
- P25E2: Faulty sensor or actuator in the control circuit
- P25E2: Wiring, connector, or fuse problem for the affected output
- P25E2: Low or unstable system voltage from the battery or charging system
- P25E2: Failed PCM/ECM or a software error
- P25E2: Poor ground connection for the control module
What to do next
P25E2 reports from the speed and idle control system. These steps cover P25E2 in general, and the exact cause on your vehicle can differ from the cause named above.
- P25E2: Verify battery voltage and charging system health first
- P25E2: Read all related module codes with an OBD-II scanner
- P25E2: Inspect wiring, connectors, and grounds for the affected circuit
- P25E2: Test the sensor or actuator with live data and actuation commands
- P25E2: Check for PCM software updates or TSBs before replacing modules
Look up another code
Enter a full code or a symptom. Press / to search. How to read a code
Type a code above, or start from a symptom or a common code.
Updated
Generic SAE J2012 definition. Last updated 2026-08-30.