Pressure Control Solenoid H Control Circuit/Open

Where it lives

For P281B, the solenoid sits on the circuit this code reports. The description of P281B reports the solenoid as open.

Check these first

• An open in the pressure control solenoid H control circuit
• A short to ground or voltage on the pressure control solenoid H control wire
• A failed pressure control solenoid H
• A corroded or backed out pin at the pressure control solenoid H connector

What to do next

1. Read pressure control solenoid H status on a scan tool
2. Command pressure control solenoid H on and off
3. Test the pressure control solenoid H control circuit for open and short faults
4. Check the pressure control solenoid H connector pins
5. Replace pressure control solenoid H if the circuit tests good
6. Clear the code and retest

Look up another code