OBD Gear Selection Actuator Position Sensor Circuit
What it means
P2E10 stands for Gear Selection Actuator Position Sensor Circuit. P2E10 is a P code, so the fault sits in the engine, transmission and emissions systems. For P2E10, work through the cause list below, cheapest checks first.
Where it lives
For P2E10, the circuit described runs through the sensor. The description of P2E10 reports a fault at the sensor.
What to check first
For P2E10, check the wiring and connector on this circuit first, since a broken terminal gives the same reading as a failed part.
Check these first
- P2E10: Faulty or contaminated sensor in the fuel/air metering circuit
- P2E10: Damaged or shorted wiring or connector for the affected circuit
- P2E10: Vacuum leak or intake system restriction
- P2E10: Failing fuel pump, injector, or fuel pressure regulator
What to do next
P2E10 reports from the powertrain control system. These steps cover P2E10 in general, and the exact cause on your vehicle can differ from the cause named above.
- P2E10: Read freeze frame data and related codes with an OBD-II scanner
- P2E10: Inspect the affected sensor wiring and connector for damage
- P2E10: Compare live sensor readings (fuel trim, airflow, temperatures) to manufacturer specs
- P2E10: Smoke test the intake system if lean or vacuum conditions are suspected
- P2E10: Replace the failed component after confirming it with live data
Look up another code
Enter a full code or a symptom. Press / to search. How to read a code
Type a code above, or start from a symptom or a common code.
Updated
Generic SAE J2012 definition. Last updated 2026-08-30.