OBD Control Module Wake-up Circuit Low
What it means
P24F0 stands for Control Module Wake-up Circuit Low. P24F0 is a P code, so the fault sits in the engine, transmission and emissions systems. For P24F0, the second digit places it in auxiliary emission controls. For P24F0, work through the cause list below, cheapest checks first.
Where it lives
For P24F0, the circuit described runs through the module. The description of P24F0 reports a fault at the module.
What to check first
For P24F0, check the wiring and connector on this circuit first, since a broken terminal gives the same reading as a failed part.
Check these first
- P24F0: Carbon buildup or blockage in the EGR, EVAP, or air injection system
- P24F0: Failed solenoid, valve, or pump in the auxiliary emissions circuit
- P24F0: Wiring, connector, or fuse fault for the emission component
- P24F0: Small leaks in vacuum or EVAP lines
- P24F0: Failing catalytic converter or oxygen sensor reporting incorrectly
What to do next
P24F0 belongs to the auxiliary emission controls system. These are the general steps for P24F0, and the exact cause on your vehicle can differ.
- P24F0: Read related codes and freeze frame with an OBD-II scanner
- P24F0: Inspect hoses, valves, and solenoids for leaks, cracks, or carbon buildup
- P24F0: Smoke test the EVAP or intake system if a leak is suspected
- P24F0: Command components on/off with a scan tool and watch them respond
- P24F0: Clean or replace the blocked or failed component
Look up another code
Enter a full code or a symptom. Press / to search. How to read a code
Type a code above, or start from a symptom or a common code.
Updated
Generic SAE J2012 definition. Last updated 2026-08-30.