Pressure Control Solenoid K Control Circuit Low

Where it lives

For P282F, the circuit described runs through the solenoid. The description of P282F reports a fault at the solenoid.

Check these first

• A short to ground on the pressure control solenoid K control circuit
• The solenoid K control wire rubbed through to ground
• A failed solenoid K coil shorted to ground
• Corrosion in the pressure control solenoid K connector
• Dirty fluid clogging the solenoid K feed

What to do next

1. Check transmission fluid level and condition
2. Measure voltage on the solenoid K control wire
3. Inspect the solenoid K harness for rubbing to ground
4. Disconnect solenoid K and recheck the control circuit
5. Replace pressure control solenoid K if the coil is shorted
6. Clear the code and retest

Look up another code